Show chart for

* All the dates and times in chart are based on the timezone on your computer.

 

The latest received telemetry analog values.

Time Vin* Temp* A3* A4* A5*
1586276061 12.75 Volt 16.5 C 0 None 0 None 0 None
1586279661 12.75 Volt 16.5 C 0 None 0 None 0 None
1586283261 12.68 Volt 16.5 C 0 None 0 None 0 None
1586286861 12.68 Volt 16.5 C 0 None 0 None 0 None
1586290461 12.68 Volt 16 C 0 None 0 None 0 None
*Used Equation Coefficients:
Vin: 0, 0.075, 0
Temp: 0, 0.5, -64
A3: 0, 0, 0
A4: 0, 0, 0
A5: 0, 0, 0

The latest received telemetry bits.

Time O1* O2* O3* O4* I1* I2* I3* I4*
1586283261
On
On
On
On
Hi
Hi
Hi
Hi
1586286861
On
On
On
On
Hi
Hi
Hi
Hi
1586290461
On
On
On
On
Hi
Hi
Hi
Hi
*Used Bit Sense:
1 1 1 1 1 1 1 1

  • Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
  • The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
  • Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
    The sent equation coefficients is used in the equation: a * value2 + b * value + c.
  • The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
  • The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
  • All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
  • A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)
Initial position
Current position
Ruler