Show chart for

* All the dates and times in chart are based on the timezone on your computer.

 

The latest received telemetry analog values.

Time RX pkts* TX pkts* CPUtmp* uptime* DX P1*
1591515520 217.8 pkts/hr 115.2 pkts/hr 35 deg.C 70 days 100.92 km
1591517322 328.05 pkts/hr 105.8 pkts/hr 36 deg.C 70 days 100.92 km
1591518220 0 pkts/hr 0 pkts/hr 36 deg.C 70 days 100.92 km
1591519119 510.05 pkts/hr 186.05 pkts/hr 36.5 deg.C 71 days 100.92 km
1591520919 432.45 pkts/hr 174.05 pkts/hr 37 deg.C 71 days 100.92 km
*Used Equation Coefficients:
RX pkts: 0.05, 0, 0
TX pkts: 0.05, 0, 0
CPUtmp: 0, 0.5, -25
uptime: 0, 1, 0
DX P1: 0.03, 0, 0

The latest received telemetry bits.

Time CPU* RAM* disk* digi* igate* eth* net* T2*
1591518220
1591519119
1591520919
*Used Bit Sense:
1 1 1 1 1 1 1 1

  • Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
  • The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
  • Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
    The sent equation coefficients is used in the equation: a * value2 + b * value + c.
  • The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
  • The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
  • All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
  • A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)
Initial position
Current position
Ruler