Show chart for

* All the dates and times in chart are based on the timezone on your computer.

 

The latest received telemetry analog values.

Time Battery* Charging/AC* GPS+Sat* Current* A5*
1594661419 100 Percent 48 Charge/On/Off 2 Sats/On/Off 0 mA 0 N/A
1594662319 100 Percent 48 Charge/On/Off 2 Sats/On/Off 0 mA 0 N/A
1594663219 100 Percent 48 Charge/On/Off 2 Sats/On/Off 0 mA 0 N/A
1594664119 100 Percent 48 Charge/On/Off 2 Sats/On/Off 0 mA 0 N/A
1594665019 100 Percent 48 Charge/On/Off 2 Sats/On/Off 0 mA 0 N/A
*Used Equation Coefficients:
Battery: 0, 1, 0
Charging/AC: 0, 1, 0
GPS+Sat: 0, 1, 0
Current: 0, 10, -1280
A5: 0, 1, 0

The latest received telemetry bits.

Time A/C* Charging* GPS* B4* B5* B6* B7* B8*
1594663219
On
Yes
On
N/A
N/A
N/A
N/A
N/A
1594664119
On
Yes
On
N/A
N/A
N/A
N/A
N/A
1594665019
On
Yes
On
N/A
N/A
N/A
N/A
N/A
*Used Bit Sense:
1 1 1 1 1 1 1 1

  • Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
  • The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
  • Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
    The sent equation coefficients is used in the equation: a * value2 + b * value + c.
  • The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
  • The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
  • All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
  • A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)
Initial position
Current position
Ruler